Changzhou Jinhai Anti-static Floor Co.,Ltd

Now more and more electronic workshops use conductive PVC flooring (ESD tiles). Recently, the ESD tiles installation of an automotive electronic parts workshop (about 367square meters) was transformed and our ESD tiles were used. They were very satisfied with the installation effect.

Here are the steps of the ESD tiles installation, you can also check the pictures to know more details:

Step 1:

Clean at the construction site: use the sanding machine to deal with surface problems. Because the self-leveling surface may have small pores, particles and floating dust, or there may be height differences.

[Automotive Electronic Parts Plant.jpg]

Step2:

Spread the conductive adhesive evenly on the floor and cure for 10 to 20 minutes. Wait for the adhesion to rise.  Then start the installation.

[Conductive adhesive.jpg]

Step3:

Glue the tiles, and put copper tapes inside the tiles to ground every 600mm.

[lay copper strips and glue esd tiles.jpg]

Step4:

Use a tile V-shaped cutter, cut about 2/3 of the floor to open V-Shaped groove.

[V-Shaped groove.jpg]

Step5:

Laying welding rods after installing the ESD tiles.

[welding rods.jpg]

Step6:

Test electronic resistance and make sure it is an anti-static syatem. The electronic resistance is between 10^4 and 10^6Ω.

[Electronic resistance for conductive tiles.jpg]

Welcome to visit this link about electronic resistance test: https://www.youtube.com/watch?v=fy4hCQCPjq8

Step 7:

Remove the dust on the installed floor and cover it with conductive wax and finish the whole process of ESD tiles installation.

[Clean and wax the conductive tiles.jpg]

About detailed ESD tiles installation, welcome to visit this video: https://www.youtube.com/watch?v=3E69wAQDbec